Re: 1951 PROJECT... to swap or not to swap!
THANKS Bernie, I will check to see if mine is bent tonight. Also I noticed that the pass side cowl on mine .....the vent fins have been bent up for some strange reason. whoever did it, did a good job because they are consistantly BENT! at first I thought it was factory but after seeing some other pics it's not,so I guess I will be ordering both sides and replacing theem. I will post a pic tonight so you guys can see what I am talking about. question: to drill out all the spot welds what works best? just a drill bit or a spot weld cutter? I have never used a spot weld cutter so i'm not sure. thanks
Greg
|