Next I needed to replace the drip rails. After searching for repops it was apparent they were either nonexistent or they were made from inferior material (22ga thin steel). I had tried to patch them earlier and just did not like the idea so I decided to make my own.
I started with a sheet of 18ga I cut a 1 1/2 x 60" slice I cut with the plasma.
Next I needed to roll 1/8" back on itself to give me the profile I needed to match the original.
Next came the 90deg edge that directs the water run off along the channel.
Then I used the stretcher to make the radius around the top and rear of the door .
Finally all welded in
__________________
69 CST-10 SWB (disguised as a 67) 383/700r4
Jezebel
Jezebel 3.0 NEW!!!
2020 GMC 3500 Denali Duramax
2016 Harley Street Glide CVO
Roll Tide!