[64c20crewcab]

Last week of July: I worked on correcting the engine wire harness that was butchered by previous owner. Sure glad he used a lot of e-tape! No solder or connectors was used used long ago. I had another harness - near mint condition that I used to add or replace existing incorrect wires. All is taped up nice n neat an hooked up minus the temp sensor wiire. Also cleaned up the heater box n engine compartment. Did a good but quick job of it. Will worry bout perfection on the sheetmetal when I attack the body work down the line. Right now motor swap n drive train is priority.. Here are a few before n after shots....