The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 09-09-2010, 10:00 PM

i picked up the valve cover bolts today, should have some pics by the weekend!

i picked up some 1" hex head bolts from ace hardware with locking washers. its super hard trying to tighten them up, there is no room for a socket, unless i scratched up all the powdercoat on the side. i had to tighten very slowly with a wrench...kinda sucks but better than the long wing studs. im not really into those...

09-09-2010, 10:00 PM	#229
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,141	Re: Project 67 DRGNWGN - 67 Burban!! i picked up the valve cover bolts today, should have some pics by the weekend! i picked up some 1" hex head bolts from ace hardware with locking washers. its super hard trying to tighten them up, there is no room for a socket, unless i scratched up all the powdercoat on the side. i had to tighten very slowly with a wrench...kinda sucks but better than the long wing studs. im not really into those... __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_] Last edited by kev2809; 09-09-2010 at 10:01 PM.