The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

GMR-PERFORMANCE · 10-07-2010, 02:34 PM

One other thing to look at is a bell housing. These transmissions need to be spot on other wise you will roast the input bearing. I tried hays, lakewood, ( could not get them centered even with offset dowls. Final answer quicktime bell housing. Withing .001 of center with stock dowls. Plus if you plan on spooling that engine up a good bell housing is never a bad idea. If you have ever had a clutch explode or seen the after math, a scatter proof housing would be at the top of your list.

10-07-2010, 02:34 PM	#21
GMR-PERFORMANCE Registered User Join Date: Aug 2010 Location: Keller TX Posts: 836	Re: T5 vs Tremec (and now Moser??) One other thing to look at is a bell housing. These transmissions need to be spot on other wise you will roast the input bearing. I tried hays, lakewood, ( could not get them centered even with offset dowls. Final answer quicktime bell housing. Withing .001 of center with stock dowls. Plus if you plan on spooling that engine up a good bell housing is never a bad idea. If you have ever had a clutch explode or seen the after math, a scatter proof housing would be at the top of your list.