[jrdv]

*********Mods--Please move to 4x4 build section***********
This is turning into a build project!

I spent about 6 hours on the truck last night.
I took off the brake booster and master cylinder, steering column and shaft, and I did a lot of sanding.

I am going to rewire the truck with the Painless harness. I think that is the best way to go in the long run. I hate wireing!

The rust issue is a little worse than I thought.
I can make a patch just fine, but what do I do about the inner rust. There is only one hole in the floorboard.
Should I spray it with rust inhibitor and patch?