Quote:
Originally Posted by jaros44sr
could you give me a rough estimate of what you might charge so I can figure how much I might sell the intake for...
|
It takes about an hour to prep it, weld it up, machine it to the right shape then re-thread the hole so figure $50 to $80 labor & materials depending upon how much of the boss is damaged and needs repaired. Yours doesn't look too bad so I would say $50 to $60.
It will look good when done just not like it was unrepaired. The repaired area will be smooth and not sand cast finish. You can rough it up a bit but I haven't been able to make it look exactly like the sand cast finish.
__________________
miSSed opportunity - ground up creation of an AWD 1994 454 SS that never was
http://67-72chevytrucks.com/vboard/s...d.php?t=795577
69 C10 shortbed stepside 400 small block - built like what a super sport truck could have been
69 K20 lwb TBI 350 4L60E NP208 14-bolt Dana-44 w/disc
68 Camaro SS / RS 500hp 439 inch roller cam big block 4L80E
79 Malibu TPI 350 4L60 w/ Z28 steering & sway bars