Got this piece cut out and shaped for the latch mechanism.
The front of the rear doors are quite different from the front of the front doors.
This shows how I will have to modify the curve for the front of the B pillar
I am starting to make a hinge panel. The hinge mounts need to come together 1.5". I made a template off the top hinge mount and transfered the pattern to the lower hinge mount for the door stop hole.
There is also a "taper" to the front door that will need to get straightened. I plan on using the hinge panel and the support and grafting it onto the door shell.
Chopped and tacked
I'm trying to keep the inner support as in tact as possible.
