Quote:
Originally Posted by mcboomport
Nice brother! On the crossmember, you don't have to have the plates as big. That way you won't have to shimmy it out. For example, look at my porterbuilt one, It only has two bolt holes on each side. It is about 2 inches where it bolts. This way you could also run your lines easier. Not saying your idea isn't good. I just think it could be simpler and still function.
Posted via Mobile Device
|
Damn, that crossmember is way simpler than mine. How easy is the install?
Couldnt find that X-member on nates site, but from the others im guessing it was around 75 bucks?
On a side note...I have my bridge setup with around 8" of notch. I think i read on your thread that you have a total of 7 3/4 notch? My question is that i set mine up to lay stock frame, but your z'd and have a 2x4'd frame. Is my notch too big?
i want just enough to lay frame, so my bed floor is as low as possible.
how tall are your tires?