The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

funkytechmonkey · 07-02-2011, 05:51 PM

I started ordering all my stuff thru CPP and didnt like the service I was getting so I canceled everything that hadnt shipped and sent my CPP notches back. I got my notch thru Porterbuilt and I have to tell you.... It was the best decision I ever made. I would much rather support Nate than order anything thru CPP unless I HAVE TO.

As far as installing the notch..... MEASURE TWICE... CUT ONCE. lol

That is one thing I did learn. If I were to do it again it would be alot easier. Get a good drill bit and varible cord drill. You will kill a cordless drill and if you try to use a crappy drill bit you will eat thru 3 or 4 of them.

Good luck man... Where is your build thread?

07-02-2011, 05:51 PM	#61
funkytechmonkey Registered User Join Date: Jan 2011 Location: Lawrenceville, GA Posts: 1,080	Re: Project "Funky Monkey" I started ordering all my stuff thru CPP and didnt like the service I was getting so I canceled everything that hadnt shipped and sent my CPP notches back. I got my notch thru Porterbuilt and I have to tell you.... It was the best decision I ever made. I would much rather support Nate than order anything thru CPP unless I HAVE TO. As far as installing the notch..... MEASURE TWICE... CUT ONCE. lol That is one thing I did learn. If I were to do it again it would be alot easier. Get a good drill bit and varible cord drill. You will kill a cordless drill and if you try to use a crappy drill bit you will eat thru 3 or 4 of them. Good luck man... Where is your build thread? __________________ Never wrenched a day in my life and now... Im doing a frame off restoration on a 1968 C10 with a Porterbuilt Dropmember, Acuair E-Level kit, Boyd Welds Gas tank and mild c-notch. Click here to view my build