The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

ncgamedog · 07-08-2011, 05:59 PM

Both axles have been completely stripped down, cleaned, and all new bearings, seals, ball joints, u-joints, wheel studs, brakes, ect. have been installed.

The paint being used is SEM Rust Shield chassis paint which uses its own hardener. Its supposed to be super tough stuff, and lays down much nicer than POR 15 IMO.

Many thanks to Chris at MarsFab for his hard work and attention to detail on the completion of the rolling chassis!! His customer service has been second to none!!

07-08-2011, 05:59 PM	#7
ncgamedog Registered User Join Date: Jul 2007 Location: Union Grove,NC Posts: 58	Re: "Old Bill" 1968 Chevy 4wd resto/build Both axles have been completely stripped down, cleaned, and all new bearings, seals, ball joints, u-joints, wheel studs, brakes, ect. have been installed. The paint being used is SEM Rust Shield chassis paint which uses its own hardener. Its supposed to be super tough stuff, and lays down much nicer than POR 15 IMO. Many thanks to Chris at MarsFab for his hard work and attention to detail on the completion of the rolling chassis!! His customer service has been second to none!!