The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

changethis · 10-04-2011, 04:49 PM

I set mine at 4 degrees and I made my transmission crossmember. I took and cut the bracket off of the s10 crossmember and bolted it to the tranny. then centered the tranny and set it at 4 degrees and welded a piece of 2 inch square tubing to it then made brackets and welded them to the frame and bolted them to the new crossmember. I would post pictures but I'm not that smart. Its not that hard to do it just took a few minutes

10-04-2011, 04:49 PM	#26
changethis Registered User Join Date: May 2011 Location: Marshfield Mo. Posts: 12	Re: 51 GMC 5 window+S10+5.3/4l60E I set mine at 4 degrees and I made my transmission crossmember. I took and cut the bracket off of the s10 crossmember and bolted it to the tranny. then centered the tranny and set it at 4 degrees and welded a piece of 2 inch square tubing to it then made brackets and welded them to the frame and bolted them to the new crossmember. I would post pictures but I'm not that smart. Its not that hard to do it just took a few minutes