The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - my '64 c-10 swb project with steel floor from a '70

summerj · 11-06-2011, 07:31 AM

Chad64chevy,

Nice Job on the build. I am in the middle of a 65 build. Like you I am Trying to do it without breaking the bank. I have been Hitting a lot of u pull yards for OEM parts. I like your brake boost set up. I pulled a vacuum boost master from an early 90's 1500.($20) Have not installed it yet but now I am thinking will the med size cam in my 350 be too radical fro proper brake boost? I guess I will find out when I install. Any draw backs to the Hydro boost set up? I have seen a few in the yards around here. Cheap.$25-30 (Side note... on your upper ball joints where you drilled out your factory rivids...turn your bold over so they are facing down. this will give you more clearance. and its safer)

11-06-2011, 07:31 AM	#117
summerj Registered User Join Date: Sep 2011 Location: Orlando,Fl. Posts: 107	Re: my '64 c-10 swb project with steel floor from a '70 Chad64chevy, Nice Job on the build. I am in the middle of a 65 build. Like you I am Trying to do it without breaking the bank. I have been Hitting a lot of u pull yards for OEM parts. I like your brake boost set up. I pulled a vacuum boost master from an early 90's 1500.($20) Have not installed it yet but now I am thinking will the med size cam in my 350 be too radical fro proper brake boost? I guess I will find out when I install. Any draw backs to the Hydro boost set up? I have seen a few in the yards around here. Cheap.$25-30 (Side note... on your upper ball joints where you drilled out your factory rivids...turn your bold over so they are facing down. this will give you more clearance. and its safer)