The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

BobbyK · 11-09-2011, 03:58 AM

I stood the trans on it's end to install the new output shaft.

It should slide in easily with no binding and only a slight interference fit.

What it looks like fully seated

The next 3 pic's are just for reference.

All the valve body bolts are 10mm

There is only one 8mm bolt for the Aux. Valve body and one 13mm bolt for the detent spring.The pump cover bolts and pan bolts are also 13mm.

I'm now waiting on a seal kit from TCI.

I'll post pic's when I get more done.

.

11-09-2011, 03:58 AM	#29
BobbyK Registered User Join Date: May 2000 Location: Petrolia,Ontario,Canada but working in Port Huron,Mi. Posts: 1,771	Re: So I'm at a light....(PIC'S) I stood the trans on it's end to install the new output shaft. It should slide in easily with no binding and only a slight interference fit. What it looks like fully seated The next 3 pic's are just for reference. All the valve body bolts are 10mm There is only one 8mm bolt for the Aux. Valve body and one 13mm bolt for the detent spring.The pump cover bolts and pan bolts are also 13mm. I'm now waiting on a seal kit from TCI. I'll post pic's when I get more done. . __________________ 71 blazer,350SBC,approx.375HP,700R4,factory GM TPI.Dual electric fans,33x12.5x15 ATR on stock suspension. Petrolia,Ontario,Canada but working in Port Huron,MI. See ALL my Blazer pic's HERE Last edited by BobbyK; 11-09-2011 at 02:20 PM.