|
Re: Driveshaft Question: 1 piece or 2 piece?
The swb truck has a short enough shaft, to run a 1 pc unit....& as long as you have the room for a larger tube shaft(you need that on a 1 pc), I would agree with Larry. My reasoning is that you have less parts, & less ANGLES to play with(less headache to setup)  If the truck is "layin rail", you might be better off with a 2 pc (for clearance through the crossmember). Personally, I would run a 1 pc shaft in my longhorn....if I could (no go due to lenght tho).  crazyL
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|