The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jthomass · 12-20-2011, 05:26 PM

Looking for some more advice. I have been working on the inner rocker and have it tacked in place. I clamped the outer rocker where it is suppose to go and between the inner and outer rocker I have a 3/8" gap on the back end and a 5/8" gap on the front. It is hard to see in the pic but the gap I am talking about is where the rubber seal goes. I am thinking if the outer rocker is lined up properly the with the front and back that the difference in the gap with the inner rocker shouldnt be the end of the world, but I would like some feedback if anyone else has run into this??
Thanks

12-20-2011, 05:26 PM	#18
jthomass Registered User Join Date: Aug 2010 Location: Fargo, ND Posts: 51	Re: Start of 72 ochre Blazer build thread Looking for some more advice. I have been working on the inner rocker and have it tacked in place. I clamped the outer rocker where it is suppose to go and between the inner and outer rocker I have a 3/8" gap on the back end and a 5/8" gap on the front. It is hard to see in the pic but the gap I am talking about is where the rubber seal goes. I am thinking if the outer rocker is lined up properly the with the front and back that the difference in the gap with the inner rocker shouldnt be the end of the world, but I would like some feedback if anyone else has run into this?? Thanks