View Single Post
Old 02-12-2012, 02:02 AM   #127
flamingbig10
6.0 powered square
 
flamingbig10's Avatar
 
Join Date: Feb 2008
Location: Mesquite texas
Posts: 3,459
Re: The Good, The Bad and Ugly from Harbor Freight

I bought a few things from harbor freight over the years, some work great, some work some what, and some don't work at all
the good
us general 56" roller tool cabinet, works great I use it at work for my every other day tools
us general 5 drawer service cart, Ive been using it every day loaded down with tools for a year and half, the only problem ive had is the floor has buckled, and it looks like the casters need a 4 wheel alignment
us general 4 drawer service cart, I purchased it for truck parts storage last month works great so fare
earth quake 1/2" impact works great it work just as hard as a snap on
bad
wire strippers I stripped about 5 12 gauge wires and they broke
1.5 ton aluminum floor, tipped over on me while I was changing a flat on the right rear on my truck dented the gas tank and bed
ugly
1/2 drive metric swivel sockets I broke two with one hit of the impact pieces went flying
I purchased a lot more thing then this oh its reminds me I haven't been since last month I'll have to make a run tomorrow
__________________
Aaron
1980 c-10 short bed lowered, cammed 6.0, 4l80e 3600 stall, smp tune, wilwoods, and flames best time so far best et 7.86 @87 on motor 7.57 90 on a 75 shot
Build http://67-72chevytrucks.com/vboard/s...d.php?t=283326
flamingbig10 is offline   Reply With Quote