The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Detroit3100 · 02-28-2012, 01:47 PM

Sheet metal repair parts were just ordered from Top Banana. Will report back. Did a frankenstin job to a rear fender but it will work for the shop truck.

Need to find some 1/4 thick rubber for the cab/bed mounts any suggestions??

Also Mounted the drivers door for the cab repair fit and also pulled the rest of the LQ9 harness off the motor and gathered the underhood fuse panel for wiring. Gonna try to use the underhood panel for all of the truck and add the needed wiring.

02-28-2012, 01:47 PM	#70
Detroit3100 Registered User Join Date: May 2006 Location: Detroit Posts: 73	Re: 1950 LQ9 conversion Sheet metal repair parts were just ordered from Top Banana. Will report back. Did a frankenstin job to a rear fender but it will work for the shop truck. Need to find some 1/4 thick rubber for the cab/bed mounts any suggestions?? Also Mounted the drivers door for the cab repair fit and also pulled the rest of the LQ9 harness off the motor and gathered the underhood fuse panel for wiring. Gonna try to use the underhood panel for all of the truck and add the needed wiring.