Quote:
Originally Posted by BLE 'BURBAN
I'd just remove the pivot joint at the front of the door as well as the vertical lock rod going up to the knob.
Then get a 3 ft piece of small diameter round stock to replace the horizontal rod, bend it to fit the rear pivot and run it through a small hole in the front leading edge of the door. from there, either thread it to put a knob on it or simply bend the end of the rod down 90* leaving enough clearance to grab it with no dificulty to lock/unlock the back door.
|
could you draw something up for me? I dont quite get where you are going? I am more a visual guy