The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

erikh09 · 03-11-2012, 10:41 PM

Thanks! The spindles were 299.00 but they made the job easier since they adapt to the 3/4 ton upper and lower control arms. Basically from the spindle out is 1/2 ton. Everything else remains 3/4 ton. The springs were 114.00. If your are decent you may just want to cut them and reuse. Mine were pretty worn. New master cylinder, rotors, calipers, and misc. odds and ends came to about 200.00. ECE sells an entire kit that includes everything for 750.00 I believe but I did not want to pay the extra shipping costs for all of that weight espacially since I can get the rotors and all from a local parts store. Hope this helps and good luck with your project!

03-11-2012, 10:41 PM	#3
erikh09 Registered User Join Date: Oct 2011 Location: Oxford,Pa Posts: 89	Re: Front is done....now on to the rear! Thanks! The spindles were 299.00 but they made the job easier since they adapt to the 3/4 ton upper and lower control arms. Basically from the spindle out is 1/2 ton. Everything else remains 3/4 ton. The springs were 114.00. If your are decent you may just want to cut them and reuse. Mine were pretty worn. New master cylinder, rotors, calipers, and misc. odds and ends came to about 200.00. ECE sells an entire kit that includes everything for 750.00 I believe but I did not want to pay the extra shipping costs for all of that weight espacially since I can get the rotors and all from a local parts store. Hope this helps and good luck with your project!