The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs...

76C10Stepside · 03-31-2012, 04:26 AM

Good stuff! I guess you don't need to remove any powder if you are coating the entire piece (and don't apply way too much).

Wish I had access to free corrugated metal! That stuff's getting EXPENSIVE.

Good point about not wanting to vent out all that hot air. Stove shops sell stove-top fans that use the heat from the stove to turn them. Not sure if it would move enough air.

03-31-2012, 04:26 AM	#1220
76C10Stepside Registered User Join Date: Feb 2012 Location: Olympia, WA Posts: 300	Re: '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs... Good stuff! I guess you don't need to remove any powder if you are coating the entire piece (and don't apply way too much). Wish I had access to free corrugated metal! That stuff's getting EXPENSIVE. Good point about not wanting to vent out all that hot air. Stove shops sell stove-top fans that use the heat from the stove to turn them. Not sure if it would move enough air.