|
Re: I need a picture????
Quote:
Originally Posted by FirstOwner69
On my 1969 CST/20 with 350 the wire runs along the top edge of the left valve cover then curves around the front of the head, under the exhaust manifold then up to the sensor between cylinders 1 and 3. There are a couple clips welded to the valve cover to retain it and also a connector attached to the top driver's side stud holding the water pump. I don't think I have a picture showing the clips or routing. Also, the wire was run through a 1/4" fabric loom.
|
AH just re-read your post & caught the bit about the fabric loom. Thanks!
|