[Dmill]

been a while since i posted, been getting work done on the truck

went to do my cam swap and ended up dropping the last damn lifter down into my motor.. pulled my heads so i could put it back and noticed rust in one cylinder from sitting.. pry would have been ok but dissasembled and am boring it out to a ls1 with forged internals.. expensive little lifter drop.. ended up with 7 layer headgaskets, arp head studs, dished forged pistons put my compression a little under 9.5 to 1.. gunna end up throwing a little nitrous to it also..

picked up the 4l80e trans 99' model and bought a tci streetfighter 3000 stall converter for that. starting to think that a non posi trac rear end wont cut it..