Thread
:
'55 International Metal/Body/Paint Work
View Single Post
06-28-2012, 09:31 AM
#
65
theastronaut
Registered User
Join Date: May 2011
Location: Anderson SC
Posts: 3,870
Re: '55 International Metal/Body/Paint Work
The corners around the bumper mount openings were cracked, so I ground out them out and welded them closed.
The lower grill panel sections were bent out of alignment, so I leveled the grill with an angle finder.
And then found the angles of the lower panels and made them match from side to side.
I also used the stainless ruler to make sure the panels were in line, or flush with each other.
Bottom edges trued up.
__________________
Project Goldilocks '66 C10 Short Fleet BBW Build
'65 C10 Highly Detailed Stock Restoration Thread
'78 Camaro Targa Roof Build
'55 International Metal/Body/Paint Work
'66 F100 Full Rotisserie Restoration
'40 Packard 120 Convertible Coupe Restoration
How To Restore and Detail an Original Gauge Cluster
How To Detail Sand Body Panels, Edges, Corners, Etc
theastronaut
View Public Profile
Find More Posts by theastronaut