The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

peterbuilt · 08-19-2012, 12:11 AM

Before I send PM's I thought I'd just ask here...
68 TT - did you finalize an idea you'd like to share on an easier approach to fabricating an under floor bracing bar?
Duncan & Sons - Did you ever get additional brackets made for resale to us?
FWIW - by centering my driver bucket with the steering wheel then measuring for equal distancing from console dimples I came up with the same as I found here - Existing outside front holes for bench seat are key starting references for fitting factory bucket brackets in bench seat trucks: 3/4 to 1" to right of driver outside front hole is good placement and existing passenger outside front hole was good as it stands. All other holes must be drilled after squaring tracks/brackets and marking. Not sure but the passenger seat center may have lined up with the glove box latch...

08-19-2012, 12:11 AM	#67
peterbuilt Registered User Join Date: Oct 2010 Location: Washington, DC Posts: 30	Re: Original Bucket seats installation???? Before I send PM's I thought I'd just ask here... 68 TT - did you finalize an idea you'd like to share on an easier approach to fabricating an under floor bracing bar? Duncan & Sons - Did you ever get additional brackets made for resale to us? FWIW - by centering my driver bucket with the steering wheel then measuring for equal distancing from console dimples I came up with the same as I found here - Existing outside front holes for bench seat are key starting references for fitting factory bucket brackets in bench seat trucks: 3/4 to 1" to right of driver outside front hole is good placement and existing passenger outside front hole was good as it stands. All other holes must be drilled after squaring tracks/brackets and marking. Not sure but the passenger seat center may have lined up with the glove box latch...