The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Rstone1 · 08-31-2012, 05:36 PM

I asked this question earlier and got no responce so I will ask again.

Inclination between the lower and the upper ball joint in the spindle. Is this needed, what is it used for and where is a good range to be in if it is needed?

08-31-2012, 05:36 PM	#1359
Rstone1 Registered User Join Date: Apr 2011 Location: Turlock, Ca Posts: 29	Re: Make it handle I asked this question earlier and got no responce so I will ask again. Inclination between the lower and the upper ball joint in the spindle. Is this needed, what is it used for and where is a good range to be in if it is needed?