Re: My own build thread
Sorry man those are the only pictures I took. I meant to take more but I got to workin and forgot. It isn't that hard, I was told make sure you don't take out more than 1 3/8th or you will run into problems. I would also try and make the section you take out without any curves. The way I did mine there were spots that had pretty big gaps because of the curves not lining up. It ended up working out ok but it could have been done a little cleaner. I actually dropped the crossmember back down last night so I can prime and paint it tonight. Hopefully I can get my wire wheel in all the hard to get places. The biggest thing to make sure is that you give yourself enough room so you can bolt it back into place. Its kind of hard to get a cutoff wheel close enough to make the cut because of the upper control gets in the way. If you have a good 90 degree die grinder you should be ok.
Posted via Mobile Device
|