I guess I missed that notation. The correct connector for that sender, is a typical single contact molded plug with a notch cut out on one side. Then the plug just slides over the 'T' shaped stud on the sender. You could also use a typical aftermarket female .250" spade connector.
Quote:
Originally Posted by AngryPirate
Yeah, I do believe I have a good ground (everything else lights up and reads correctly).
I just noticed in the 'overview' tab on summit it says:
"Notes Temperature sender without light."
So I guess I'll give it a shot.
Any idea what the connector for this sender looks like?
Thanks.
|