Re: 1970 Project Build
Thanks for the compliments and thanks for your advice on the crossmember through-hole cutouts. I offset the rings all the way forward and outside of te crossmember so that a fillet weld from the rear of the crossmember could complete the whole weld and seal it off. I don't have a stick welder so I'll have the welder at the muffler shop help out a little. There was a delay on this because I want room to work on the seat mounts before I have the exhaust in the way.
Posted via Mobile Device
Last edited by Johnnyfever; 10-16-2014 at 10:36 AM.
|