Quote:
Originally Posted by sourkraut
That setup looks awesome! Hit it with some bead media to give a nice finish and your set!
Posted via Mobile Device
|
Quote:
Originally Posted by dujobu
Lookin good Jim. Hope you enjoy that TPI.
|
Hey John, thanks for the comps....just always liked the looks and character lines of the tpi. Didnt think the CFO would ever release the funds, but she did. Thanks Honey!
Are you still doing powder coat...glad ya got back to working on your truck, still one of my favs.
Dusty, enjoying the hell outta it. Finally figured out the lay of the engine harness. Map, air and h2o will go down the drivers side. TPS, IAC, wiil run down the other valve cover covers, should keep it symetrical in size and away from noise from power cables. Crank, tbd, as im not sure where that goes
Maybe ill get to drill the hole this weekend, and start pulling cable
Still have to buy ignition box, and fuel pump, filter, injectors, crank trigger, so i am getting close to the end of the spendy things
Had plans to work on it over the holiday, but jeremy was sick for 7 days. What a condition that was for the wifey and i. Spent the whole time between the bathroom, bedroom, an laundry room. Oh well, joys of parenthood with a special son! Hes a tough man....