Re: Power Steering Adapter Plates
For you guys that have done this swap, what are you doing for hoses? I bought a presssure hose for a 73 C10, and no way it will work. The fittings are right (5/8" inverted flare one end, 11/16" inverted flare on the other) but the bends are just all wrong. Can't make it work.
I also tried fabbing a steel braided line with AN fittings at each end (which I have done many times on fuel lines and tranny lines) but it blew the fitting off the hose twice when I fired the engine. I understand the pressure is much higher in a power steering system, like 175PSI or something.
Anyway, I'm open to suggestion at this point. If anybody has a part number or application for a pre-bent hose/line that will work, I sure could use it.
The adapter plate and installation and everything was top notch otherwise though...very easy installation and I sure am looking forward to modern steering.
|