The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - First Build thread, Need some outsiders veis

Bandit78 · 03-02-2013, 01:34 PM

Pulled the engine to change the rear seal and it ended up in a.... (well its already out and apart, might as well rebuild it right)

The 327 wasnt in to bad of shape but there were some things that had been jerry-rigged. Like the gear drive timing set that dint fit rite with the stock timing cover and although I new what the high pitch whine was from every one thought I had a transmission problem. So I went to a double chain, had the heads rebuilt, then port matched and polished them and Put in a lunati barebones cam and lifters.

It had a decent set of cast aluminum vavle covers that were black, So I polished them up. It was my first time polishing cast aluminum up an man it took alot of hours.

03-02-2013, 01:34 PM	#3
Bandit78 Registered User Join Date: Feb 2013 Location: Discovery Bay, California Posts: 7	Re: First Build thread, Need some outsiders veis Pulled the engine to change the rear seal and it ended up in a.... (well its already out and apart, might as well rebuild it right) The 327 wasnt in to bad of shape but there were some things that had been jerry-rigged. Like the gear drive timing set that dint fit rite with the stock timing cover and although I new what the high pitch whine was from every one thought I had a transmission problem. So I went to a double chain, had the heads rebuilt, then port matched and polished them and Put in a lunati barebones cam and lifters. It had a decent set of cast aluminum vavle covers that were black, So I polished them up. It was my first time polishing cast aluminum up an man it took alot of hours.