Quote:
Originally Posted by Low Elco
Aaaahhhhh.... Happiness is a warm Sawzall. Do you have a standard Bridgeport?
Posted via Mobile Device
|
Not anymore. I had a Webb (Bridgeport knockoff) with a 9x42 table and DRO when I lived in Houston, but had no way to transport or set it up here. Sold it before the move and now have a small Grizzly mill/drill with a 8x22 table. It still uses R8 collets, so all my tooling is usable. Also had to swap my Logan 14x40 lathe for a 10x22 with a much smaller footprint. Most stuff I do anymore is small, so that's not an issue. I have a DRO for the mill but have never installed it. I was pleasantly surprised at the accuracy of the smaller equipment. If it ever gets sloppy to the point that it can't be adjusted, I'll stick the readouts on it.