[xpickup]

69CST-V, thank you

FarmerSid, thank you. Yes, sometimes the shrinkage can be a real pain. It was not too bad. I did not even have a beer the whole time I was working on it. Haha

99 to Life, thank you. Heat is everything, it can really warp a panel out. The shrinking disc can really help bring things back.

Here is a picture of where I am at with the brows. The passenger just needs the inner made and the drivers needs the outside edge finished, then ground up , metal worked and the inside panel made. The drivers was a pain. When they formed it the one leg of the panel was way longer than the other. Which threw me off. So I had the add to the inside edge a little. But it is only metal. So it is fine.

Shannon
Posted via Mobile Device
Posted via Mobile Device