The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Danna 44 and Eaton HO52 Identification Help

DD38 · 04-17-2013, 09:48 AM

I pulled the long side axle shaft and measured it. The inner shaft was 35 5/8" with 30 splines and the outer was 9 1/2" with 19 splines. According to a chart I found, those sizes match a 1967-69 Chevrolet K-20 3/4 ton (35.63" with 30 splines and 9.53" with 19 splines). Not sure how the overall size WMS-WMS is shorter. I might pull the other axle shaft and measure it just to see what I come up with. As for now, I think I will make a tie rod and be done with it until I can upgrade to some disk brakes. Thanks for all the help

04-17-2013, 09:48 AM	#11
DD38 Registered User Join Date: Apr 2013 Location: Maryland Posts: 11	Re: Danna 44 and Eaton HO52 Identification Help I pulled the long side axle shaft and measured it. The inner shaft was 35 5/8" with 30 splines and the outer was 9 1/2" with 19 splines. According to a chart I found, those sizes match a 1967-69 Chevrolet K-20 3/4 ton (35.63" with 30 splines and 9.53" with 19 splines). Not sure how the overall size WMS-WMS is shorter. I might pull the other axle shaft and measure it just to see what I come up with. As for now, I think I will make a tie rod and be done with it until I can upgrade to some disk brakes. Thanks for all the help