[cortcomp]

Found a softspot (about the first 4 inches i did) and cut it out (was gooey in the middle) and about an inch or so into the cured areas on each side. I think i didn't put enough out of the tip to get a good mix. Everything else is rock solid. It was a REAL pain to cut the cured stuff, even with a razor blade and hook knife. Made a nice clean area to re-seal, in an easy part in the center back of the truck. Will likely do that, and try a really thin bead on the A pillar drip rails. Doing some 3M on the door jamb upper seams this weekend. hope to primer late next week or next weekend. Mildly annoying buy pretty sure it's my fault (like how i overfilled the ditch where the sloped area levels out and the rear drains are punched), not a show stopper, i'm sure once i fill it, it will mate well with the existing.