My plan is to run air ride and set it down pretty low. Not sure how low but I felt that the trailing arm may drag at times. I flipped over the frame and started to shave.
![](http://i1276.photobucket.com/albums/y475/66Project/CRICK-PC/66%20CHEVY%20C10/56751ade-103e-4136-9620-bf9934ab6841_zpsa174f63c.jpg)
Welded in a piece of flat plate.
![](http://i1276.photobucket.com/albums/y475/66Project/CRICK-PC/66%20CHEVY%20C10/20130628_143119_zps7315dd14.jpg)
Then cut some holes out for the exhaust.
![](http://i1276.photobucket.com/albums/y475/66Project/CRICK-PC/66%20CHEVY%20C10/52578328-8207-400b-be12-ca076447cc06_zps3c58db25.jpg)
Welded in some 4 inch pipe to regain some strength.
Well that's about all Ive done so far. I only work on it on the weekends and my wife is incredibly understanding with the time and cash it takes to do a project of this size. I hope everyone enjoys these pictures and keeps following along with my progress. Ill try and update it weekly. Comments and suggestions are always welcomed.