[hgs_notes]

I had to go back several pages and about 6 months in time to find my last punch list and cost update. Yikes! I was at $4322, and bought a new kickdown cable (16), tranny pan (42), paint supplies (didn't use them, but whatever 62) and vent window rivets and filler neck grommet (16). I also gave $50 to the body shop for the use of the booth. I would have offered more, but money is tight right now and Lowell said he was thinking $50 anyway. Can you believe that? I had the booth tied up for an entire day, used their plastic to mask stuff, more tape, on site help and guidance, etc. It's good to make friends!

So my total spent is now $4508. Any other parts I've used so far are ones I had from parting out the various trucks, swap meets and junkyard hauls over the past few years. I just keep fixing up and cleaning old stuff and re-use it as much as possible.

Punch list (in no particular order, * for priority items):
still too damn long

*Finish roll bar install
*kickdown cable to carb
*change fluid in both differentials
*make sure wire for gas gauge is hooked up to sender
Al's liner inside of tub (half way done)
inner fender tubs, paint, install
rebuild vent windows (half way done)
door glass, handles, locks, mirrors, etc.
Fab front and rear bumpers
electric fan install (got it)
plumb vac and oil gauges
seat bracket spacers, built, need to install
replace rear lift blocks with taller ones (need new u-bolts)
heater control cables and vents
heater install (half way)
wiper washer pump
manual throttle
door panels, visors, etc. (have them, need paint, cleaning, etc.)
stereo (radio in, need marine speakers and antenna)

Future plans, as time and money and ability permit:
Long travel link suspension front and rear
lockers
rock sliders
roll cage
skid plates