[99 to Life]

After I got the pieces all roughed in, I had make a lip around the whole radius of the gauge, since its not flat. So I welded a thin piece of rod all around it, no pics of that process, lots of back and forth with that, making the radius look right. But once you have the bezel in there, like the one pic, it really makes it look good.

I'm just about done with the shaping all around the gauge, I was going to lead all the welds, but I think just cause of time and money, I'm gonna duraglass all the seams and fine tune some radius shaping with it.

This last pic, I had to make some bolts for the gauge to mount to, I also didn't post on here, the section that the steering column goes in between the gauges, from the factory is offset, I later on and did not show, I moved it so the column will be centered in the gauges, its subtle but took a bit to get that right.