Quote:
Originally Posted by jorgensensc
Hart,
Sorry I didn't understand the question. When I figured out wat I wanted to use on my Speedhut canbus gauges I just looked at what gauges the escalade had. Since the gauges and DIC is all sent via canbus, I just went off of that. So, for mine I used the oil pressure, fuel level (this may be vehicle specific as some vehicles go through the BCM to the fuel gauge, mine goes straight to the ECM, then changed over to the can bus signal), tranny temp, engine coolant, and voltage. I could have done the speedo and tach, however they didn't make the speedo and tach gauges in can bus in the right size for me. They made them in can bus in smaller gauges. Hope that explains a little more.
Shawn
Posted via Mobile Device
|
No worries Shawn. I wasn't very clear in my original post
. I hadn't planned on using the CANBUS feature of the Dakota Digital gauges until I started doing some research on it. Now I want to use all of the features I can
.
Posted via Mobile Device