[yossarian19]

Well, I'd forgotten that I had a meeting at noon and a financial planning session at 2 pm.
Then, when I got home around 245 or 3, I decided to take apart the work bench and add another 2x12-8' board to the work surface. It is a *lot* more useful being 3' deep than 2'. So much so that I got the boxes of SAE tools out from under the bench, put them on top, moved the drill press and *still* have a lot of work surface.
After all of that, some goofing around, and eating dinner, I got as far as wiring up the brake switch and relay, power and ground to the relay, and verifying that I have power to the correct ECM pin when the key is on. I still have to run power from the relay back to the lights, though. My fiance gets restless if I'm in the garage past 945 or so...
Tomorrow...