[xpickup]

I started working on the aluminum roll pan tonight. It will have a 1 inch recessed area where the exhaust will come out. I had to make it wider so that I could cut out the rot on the one side. Both ends are stepped so that it can be riveted to the body and it will fit up right under the rear doors. Friday I will TIG weld it together and hopefully finish the exhaust if it does not rain or snow.

This is the second time writing this because when I attached the pictures it wiped out what I wrote. Does anyone else have this problem? I usually write in one post and post pictures in another then I do not lose what I wrote!


Shannon