Project NiteMare-1970 C10 LWB build
Another update on something I've been messing with.. front roll pans arent "legal" in my area due to lack of strength/ front end protection. So I gave this a shot. Took my factory bumper, trimmed off the top edge and sides. I made filler plates for the sides and top out of 1/4" plate steel. The bulge in the lower center of the bumper (license plate area) was cut out, flipped over and welded back in. Frame rails had to be shortened of course... all mounting hardware will still be in place, with the mounting bolts being back welded for a clean look.
|