Quote:
Originally Posted by shawno72
Very nice Keith.
|
Quote:
Originally Posted by mcbassin
Very nice work on the drive shaft. Looks like that will work.
|
Quote:
Originally Posted by Rusbuilt
Oh ok! That makes sense! lol
|
Thanks guys, saved me a lot of money from having a custom shaft made. I will have about $200.00 into this one when all said and done.
Quote:
Originally Posted by jlsanborn
Nice work man! We shortened a driveline not too long ago but just kinda figgered it out the hard way. How did you cut the weld yoke off? Were you left with any kind of "lip" to locate it back onto shortened tube nice and square?
|
Yes my brother cut the yoke off dead center of the weld being careful to only cut the shaft and not through the yoke. Once the piece was cut off he was left with about a 1" lip on the yoke that we squared up and pressed back into the shortened shaft. Once everything was square he threw some tack welds on. Then we tried it in the truck to make sure it was the correct length and the carrier bearing bolted in. Once we confirmed it was correct he fully welded it. Hope that helps.