The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

studda · 01-08-2014, 09:36 PM

The fuel line on my '53 with a 216 in it has the ends rusted to the line so the line twisted off when I went to replace the fuel pump. I have a small tubing bender that I used to bend the brake lines for my '68 GTO. My question is, what is the diameter of the steel line that I need? I can bend, cut, and flare it to my specific needs. 1/4"? I would just use the old line for comparison but it's out at my dad's with the truck and that's about 10 miles out of town so I'd have to drive out there, then back to town, then back out there, which would be too much driving.

01-08-2014, 09:36 PM	#1
studda Registered User Join Date: Oct 2013 Location: St. Clair Mo Posts: 283	'53 216 Fuel Line Diameter The fuel line on my '53 with a 216 in it has the ends rusted to the line so the line twisted off when I went to replace the fuel pump. I have a small tubing bender that I used to bend the brake lines for my '68 GTO. My question is, what is the diameter of the steel line that I need? I can bend, cut, and flare it to my specific needs. 1/4"? I would just use the old line for comparison but it's out at my dad's with the truck and that's about 10 miles out of town so I'd have to drive out there, then back to town, then back out there, which would be too much driving.