[JimH2828]

Randy, no worries on the radio cups and nuts, I understand. Sounds like the hatch lifts are no good, thanks for the very honest response.

I hope the below list is not too much........about to start a Blazer restore project.


1) I meant, the radio 3 wire black connectors with green\black speaker wire....sorry for poor description
2) 3 Boots rings $25, I'll take them.
3) I would be interested in some Soft-Ray vent glass if you can come up with a good pair.
4) Vent screw and ferrules 6x $20, I'll take your cleanest.

new items:
5) Shift knob - any of those blank for Blazer 69-70 4x4?
6) Blazer gas tank fill pipes
7) Air cleaner nut, bottom one - post 17 pic 5
8) Blazer frame mounted shift linkage bracket - post 16 pic 2 ......have spring?
9) Coiled Oil pressure line - post 17 pic 2
10) Power steering dual line frame clip with nut - post 17 pic 5
11) Is that a Blazer fuel harness in post 6 pic 5? Cuts? connectors on both sides?
12) Is that Blazer rear side panel top chrome trim in post 5 pic 4? condition?
13) I saw some heat stove parts, any outer stove pieces?
14) 2 channel pulley - post 15 pic 2
15) Spark plug shields and retainers......complete set? Post 14 pic 2
16) Can you come up with a complete AC bracket set? post 14 pic 4
17) Are any of those transmission fill tubes and dip sticks for a TH350? post 4 pic 2
18) T-3 3 pong headlights - post 2 pic 5 and post 4 pic 4
19) Emergency brake pedal and bracket - post 2 pic 2
20) Med Blue glove box door hinge and screws - post 1 pic 2
21) Can you come up with a decent kick panel vent set? vents, pulls, vacuums, mount pieces.......I'm not even sure what is complete....I have a 70 Blazer CST with AC.
22) Any blazer carpet trim?
23) Any blazer tailgate seal trim? maybe in post 33 pic 3
24) Any ignition lock cylinders with stamp codes? post 27 pic 4
25) Is that a Blazer length main rear run wire harness? post 3 pic 5 cuts?
26) Any blazer seat parts?
27) any 4x4 pitman arms with bolt\nut?


Thanks
Jim