I'm getting an hour in here and there. Just about done the rear but I ran into a problem. The instructions don't explain how to use the 2 different stock bolts (which one is for the upper and for the lower mount).
This fellow highlighted the problem but no solution was posted:
http://67-72chevytrucks.com/vboard/s...d.php?t=596711
Anyone know how to address the question in the thread at the link above?
I found these instructions for a previous gen C10 but if I do the same as in the photo at the following link, the shock is upside down and there are not enough threads for the nut.
http://www.customclassictrucks.com/t.../photo_23.html
Hector, thanks for offering the lowering blocks. I'll see if I need them once I get this on the ground.
Also, anyone know the torque spec on the rear spring nuts? Not in ECE instructions.