[airbrushguy]

Doors went on, everything aligned well. Took door back off, fitted outer rocker, took outer rocker back off, painted weld-thru primer (should have done this before fitting outer rocker).
Will grind down most of welding, afraid to grind flat because metal might get thinner. Need to screw outer rocker on one more time, hang door once more, and if all is good, do final welding.
Then on to rear support and cab corner. Hopefully the driver's side has helped me to do passenger side faster when I get there. Things fitting well does give encouragement even if it does seem like you're fitting and removing way too much.
Ultimately I will Por-15(top and bottom), DynaMat, insulate and cover with rubber floor matting....and no one will know any of this went on, ha.
But it will have to be quieter and less drafty!