The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

b.sharp · 02-21-2014, 05:18 PM

It might be a lot easier just to swap the dashes in these two cabs. I took a dash out of a GMC truck in the junk yard. Took me an hour. There are two or three bolts on each side underneath and about thirty spot welds across the top on the bottom windshield lip. I think it would be a lot easier than replacing the whole floor system and cost you a lot less money. I can send you pictures of the dash I took out of the GMC truck for reference if your interested.

02-21-2014, 05:18 PM	#10
b.sharp Registered User Join Date: May 2006 Location: Frankfort, Kentucky Posts: 508	Re: Daddy Bob's 1964 GMC 3/4 Ton It might be a lot easier just to swap the dashes in these two cabs. I took a dash out of a GMC truck in the junk yard. Took me an hour. There are two or three bolts on each side underneath and about thirty spot welds across the top on the bottom windshield lip. I think it would be a lot easier than replacing the whole floor system and cost you a lot less money. I can send you pictures of the dash I took out of the GMC truck for reference if your interested.