[silverbear]

Got the exhaust welded up and temporarily hung. I need to make some mods to the bump stop brackets to give enough clearance for the mufflers to fit up higher in the frame. I was worried I would not have enough clearance for the X pipe, but even hanging low where it is at gives me almost 10 inches between the pipes and the drive shaft. I still have to add tail pipes but this is enough exhaust that I can run the truck until I figure out what I want to do. I am thinking about running the tail pipes straight out the back right through the bumper. My current bumper is rusted out so now will be a good time to experiment.




I also got the gas tank hung back in place.